Om2000A+ Firmware Upgrade - OM POWER OM2000A+ Manual

Open Basic Setup (or WAN Settings or similar, depending on router) and note the WAN IP Address
value.
Now you are ready to work with OM2000A+ over the internet.

7.6. OM2000A+ firmware upgrade

Download firmware upgade software and latest firmware file for OM2000A+ from the official OM Power
website http://www.om-power.com/downloads. Store it to OM2000A folder in your PC.
Use serial null modem cable and connect TCVR port on OM2000A+ rear panel with COM port on the PC.
Open folder OM2000A , find MX460L.exe file and run it.
In Remote Control software, open
Settings. Enter the IP Address and Port
number you set up in previous point in
your router. IP Address is the WAN IP
Address in basic setup page and Port
number is the Port (or Public Port if
Type of supported TCVR and
separate) in forwarding page. When
done, click enter.
frequency are visible on the
AUTO LED is ON.
working
display.
47