OM POWER OM2000A+ Manual page 15

We recommend to use CAT connection always when possible, because in such a case OM2000A+ has permanent
information about the transmit frequency and is immediately ready for transmitting.
With setting NO CAT the OM2000A+ detects transmit frequency from the input signal. With the input signal
frequency changing the PA automatically reacts and tune itself to optimal output parameters. Tuning takes abt.
1sec. inside the band, abt. 2 sec if band is changed. By NO CAT using we recommend to use BAND DATA
information due to the much faster band changing
Screen shows settings possibilities for CAT,
ANTENNA, DISPLAY, NETWORK SETTING, EBS,
BLOWER and other infos.
Scroll to CAT SETTINGS (up or down) and touch
SET.
Scroll to your TCVR family (up or down) and
select bit rate (left or right), then press SET.
Or select NO CAT and press SET.
.
If you choose YAESU or ICOM NEW, after SET
pressing you will go to deeper level which
allows you to select specific type of TCVR. See
the following picture for ICOM NEW selection,
for example.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
m
15