Table of Contents
Advertisement
Information Display - Basic View
The following values are depicted on the basic display:
1. Tractor type
2. Engine revolutions (number of engine revolutions per
minute)
3. Voltage in the electric system of the tractor
4. Total number of motor-hours in service
Information Display - Maintenance Notifications
In case any maintenance operations are required, a label
STOP will show up on the display and the necessary
maintenance operation in English is displayed in the top
right corner:
COOLANT LEVEL - Check and top up coolant in the
equalizing tank
AIRFILTER - Carry out maintenance of the engine airfilter
Shall such a situation arise, carry out the operation shown
on the display according to the chapter Maintenance
Instructions.
Information Display - Fault Notifications
If a serious engine fault occurs, a label STOP and the
SPN fault code number will show up on the display.
In the picture, the example SPN: 94 means a fault code of
94.
Shall such a situation arise, put the tractor out
of action and contact a service place.
Manual fuel control lever
a - idle run
b - maximum supply
The lever enables to set engine revolutions in the whole
range (a) to (b).
ACQUAINTANCE WITH THE TRACTOR
31
NM14D047
NM14D048
NM14D049
Advertisement
Table of Contents
