Maintenance And Tips; Engineering Mode; Troubleshooting - LifeSpan R5i Owner's Manual

Interactive trainer

Hide thumbs Also See for R5i:

Owner's manual (41 pages)

Table Of Contents

Table of Contents

Engineering Mode

To Enter Engineering Mode, Press and hold the Enter Button and the Up

button for 3 seconds. The console will beep and display Engineering Mode.

Function

Press Enter. The display will show Roller. This is something

that does not need adjustment.

Press Enter. The display will show Select the units.

Press the ▲ or ▼ buttons to change between Si

(metric) or EN English modes.

Press Enter. The display will show Set calendar On or Off.

Use the ▲ or ▼ buttons to change between On or Off

Press Enter. The display will show Total Distance. It will

show 1 digit on the left and 3 digits on the right for a

total of 4 digits. This is the total number or miles or

Kilometers accumulated.

Press Enter. The display will show Total Hours. It will

show 1 digit on the left and 3 digits on the right for a

total of 4 digits. This is the total number of hours the

bike has been used.

Press Enter

Troubleshooting

If you have a question that isn't answered in this Owner's Manual, visit our website

at www.LifeSpanFitness.com or call us at 877.654.3837 option 4.

Problem: Unit is unstable or rocks while in use.

Solution: Make sure unit is on a solid, level surface. Adjust the rear adjustment

feet until all 4 feet are sitting solid on the floor.

Problem: Rough feeling in pedals when in use.

Solution: If everything is tight, contact LifeSpan Customer Service for

replacement pedals.

Problem: Excess play in the handlebars or frame components.

Solution: Using the provided assembly tools, go over the R5i to make sure all

assembly hardware is tight.