LifeSpan R5i Owner's Manual page 27

Assembling Your R5i Recumbent Bike
Step 9: Console Upright Assembly
A. Slide the Upright Cover (11) a third
of the way up the Console Upright
Assembly (10) as shown below.
NOTE: Remove wire ties from
connectors (N) and (O).
B. Align the Console Upright Assembly
(10) with the Console Upright Bracket
(P) on the Main Frame Assembly (1).
Plug the two Connectors (N) from the
Console Upright Assembly (10) into
the two Connectors (O) coming from
the Main Frame Assembly (1).
C. Tuck excess wiring into the bottom
tube of the Console Upright Assembly
(10).
D. Install three M8x50L Countersink Bolts
(27) through the Console Upright
Assembly (10) and into the Console
Upright Bracket (P) Do not tighten
until all three bolts are installed.
NOTE: Be Careful not to pinch the
wiring when securing the upright
assembly (10) to the console upright
bracket (P).
E. Slide the Upright Cover (11) down the
Console Upright Assembly (10) to cov-
er the mounting bolts and bracket.
Press down firmly to snap into place.
28
11
N
10
27
10
O
P