Table of Contents
Advertisement
Assembling Your R5i Recumbent Bike
Step 4: Front Support Assembly
A. Check that the Seat Mount (14) is centered along the Seat Rail As-
sembly (4), and tighten the Seat Mount Stop Lever (B) to lock the Seat
Mount on the rail.
B.
Align the Seat Rail As-
sembly (4) with its front
(C) and rear (D) brack-
ets on the Main Frame
Assembly (1).
C. Install six M8x15L Bolts
(17) and Washers (18)
through the brackets (C
and D) into the threaded
holes on the Seat Rail
Assembly (4). Do not
tighten any bolts until all are installed.
D. Once all six bolts (4 in front and 2 in rear) are installed, fully tighten.
E.
Plug Connector(s) (E) into Connector(s) (F).
It does not matter which connector(s) plug into each other as long as
F.
Push the excess wire into the hole in the Main Frame Assembly (1)
until the Plastic Grommet (G) is fully seated in the frame.
G
22
Remove wire tie from the Connectors (E) and (F).
both connector(s) are plugged in.
E
F
1
1
NOTE:
NOTE:
4
B
14
C
18
17
G
1
4
D
4
Hide quick links:
Advertisement
Table of Contents
