Mother Board And Led User Interface Board - Biomark IS1001 Operation User's Manual

Description
Note: Optional LED User Interface Board, Remote Communication Board, USB Data Logger
Board and BLE Data Logger Board are all mutually exclusive. Only one can be installed at a time.

Mother Board and LED User Interface Board

The Mother Board incorporates the following: input power connection and monitoring, CPU,
internal memory, optional accessory boards interface, USB local communication interface, CAN
Bus interface, Date/Time synchronization interface and FDX-B tag and HDX tag signal decoding
filters. This board also contains two yellow antenna tuning status LEDs (OFF+ and OFF-) that
indicate if the antenna is out of tune and if the tuning capacitance needs to be increased (OFF+)
or reduced (OFF-).
The LED User Interface Board incorporates IS1001 status LEDs, an IS1001 beeper with a
potentiometer to adjust its volume, and an IS1001 reset button.
The four IS1001 status LEDs indicate the following:
•
Green "POWER" LED indicates that power has been applied to the IS1001 reader.
•
Yellow "SCAN" LED indicates that the IS1001 reader is in Scan mode.
•
Red "TUNED" LED indicates that the antenna is properly tuned to the set target phase.
Flashing LED indicates that the IS1001 reader is performing Antenna Full Tune process.
•
White "TAG" LED indicates that a tag ID was successfully decoded.
3V Power
4
USB
LED Port
5V Power IS1001
LED Status LEDs
IS1001 DEBUG IS1001 Reset
Beeper Port
IS1001 Beeper
Volume
Potentiometer
Antenna Tune
Button Status LEDs
FDX-B Filters
Output Test Point
IS1001 Reader User Manual