Usb Port Operation - Biomark IS1001 Operation User's Manual

USB Port Operation

The IS1001 reader can be operated and configured locally using the USB communication port.
Note: BioTerm or BioStat and the proper driver must be installed on your computer. If your
computer is missing these programs, see the Pre-Installation Steps section on page 8.
1. Connect the IS1001 reader to a local computer using a USB type A-to-mini USB type B cable
(not supplied).
2. Start the BioTerm or BioStat communication program.
3. In the Serial Port box, make sure that COMx Silicon Labs CP210x USB to UART Bridge is
selected (where x is the port number assigned to the local computer's USB port).
4. In the Baud Rate box, make sure you match the IS1001 reader's Local Port speed setting.
5. Make a serial port connection to the IS1001 reader by clicking on the Open button.
6. To verify the connection between the computer and the IS1001 reader, within BioTerm or
BioStat Traffic window type ? and then press Enter. A list of available commands should be
displayed. All the commands are described in detail on page 28.
7. Type appropriate commands to perform the desired actions.
8. To save all communication data, such as tag IDs, alarm messages, reports, etc., in a text file
configure the BioTerm utility program to act as a data logger by selecting Tools > Enable
Capture or by clicking on the Text Capture On/Off button.
IS1001 Reader User Manual
USB Port Operation
21