Description; Models; Features - Biomark IS1001 Operation User's Manual

Description

The IS1001™ is a high performance, ISO-compliant stationary RFID transceiver designed for
detecting, storing, and transmitting FDX-B and HDX PIT tag IDs in permanent installations. It is
specifically designed for applications that require low power consumption, large detection area,
and high adaptability to environmental changes.
Each IS1001 reader's antenna exciter circuitry is designed to operate large antenna (as large as
4 feet by 20 feet or similar) with low coil inductance to provide a detection area that is tolerant of
environmental changes. In addition, IS1001 reader can carry out independent automatic dynamic
antenna tuning while providing ample power to its antenna for optimal tag activation and detection.
The IS1001 reader saves tag data and system information in its internal memory. It can also save
the information on a removable memory device or communicate the data in real time via various
paths to a host computer or data logger.

Models

There are two available models of IS1001 reader:
•
IS1001: This is the base model. It requires a 24 V DC power input. This model uses IS1001
Application Firmware v1.x.x.
•
IS1001-12V: Same as IS1001 except that it requires a 12 V DC power input and it does
not offer adjustable antenna power output. This model is identified by a yellow model
number sticker on the Mother board. This model uses IS1001 Application Firmware v2.x.x.

Features

The IS1001 reader incorporates the following features:
•
Dynamic antenna auto-tuning
•
Support for a wide range of antenna inductances
•
Adjustable antenna output power (not available on IS1001-12V reader)
•
Detection of ISO-compliant FDX-B and HDX PIT tags
•
Detection of Fastag™ FDX-B Half-Telegram PIT tags
•
FDX-B tag detection signal level measurement and BioTherm™ tag temperature detection
•
Automatic system performance diagnostics using a Virtual Test Tag
•
Flexible and configurable to support a wide array of system applications
•
Configurable non-volatile setup parameters
•
Non-volatile internal memory for storing up to 78,583 tag IDs and 1,023 status reports.
•
Storing real-time information such as tag IDs, alarms, messages, and reports on an
external USB flash drive (requires optional USB Data Logger Board)
•
USB port, RS-232 and Bluetooth port for local access (requires optional BLE Data Logger
Board)
•
Ethernet and fiber optic ports for remote access (requires optional Remote
Communication Board)
•
DC power input (24 volts for model IS1001, 12 volts for model IS1001-12V)
•
Remote and field upgradeable firmware
IS1001 Reader User Manual
Description
1