Noise Report Structure; Diagnostic Data Report Structure - Biomark IS1001 Operation User's Manual

Reports Structures

Noise Report Structure

Parameter
Present Noise
Maximum Noise
Average Noise
Time Averaged Over
NRP
Note: The report contains information from the time when the previous noise report was
generated or from the time when reader was powered up or reset.
Example
INF: Start Of Noise Report
Present Noise:
Maximum Noise:
Average Noise:
Time Averaged Over:
INF: End Of Noise Report

Diagnostic Data Report Structure

A Diagnostic Data report contains important diagnostic information for the IS1001 reader. The
report can be generated using the RDD command.
Status Message
Reader
Operation Mode
Detection Counter
Tags in Memory
Status Reports in Memory
Input Voltage
Exciter Voltage
Antenna Tuning
Antenna Current
Tuning Capacitors
Tuning Phase
Tuning Relative Phase
FDXB Signal Level
Temperature
44
Value
The value is presented in milliVolts peak-to-peak and in percent
The value is presented in milliVolts peak-to-peak and in percent
The value is presented in milliVolts peak-to-peak and in percent
The amount of time used when computing the average. The time is shown in a H:MM:SS
format. For example: 0:01:00 = 60 seconds.
Identifies an abbreviated noise report message containing the reader ID, the date and time
that the report was generated, the noise values in percent, and the time averaged over in
seconds.
85 mV (9%)
177 mV (19%)
162 mV (18%)
Message Information
Reader operation mode setting (Scan/Standby)
Detection counter value
Number of tag IDs presently stored in memory and percentage of memory used
Number of short status reports presently stored in memory and percentage of memory
used
Measured input voltage in Volts DC
Measured exciter voltage in Volts DC
Antenna tuning status (Tuned/Tuning/Out Of Tune)
Measured antenna current in Amperes peak-to-peak
Antenna tuning capacitance setting (0 – 1023)
Measure tuning phase
Measured tuning relative phase
Measured FDX-B signal strength in milliVolts peak-to-peak and in percent
Measured reader temperature in degrees Celsius
0:01:00
IS1001 Reader User Manual