Biomark IS1001 Operation User's Manual page 38

Commands
Measurements
MCG {0-200}
MCO {0-200}
Memory
MED
MEE
MSD
MSR {1|0}
MTD
34
automatically activated when this parameter is set to On and
deactivated when this parameter is set to Off.
Set Antenna Current Measurement Gain
Sets antenna current measurement gain value. Valid values are 0 –
200. Default is 120.
The antenna current measurement is calibrated and tested at the
factory.
Set Antenna Current Measurement Offset
Sets antenna current measurement offset value. Valid values are 0
– 200. Default is 110.
Download Entire Memory
Initiates the download of all data contained in the IS1001 reader's
memory.
The Esc key can be used to cancel the process.
Note: The data will be sent only to the port from which the memory
download was requested.
Erase Entire Memory
Permanently erases all data contained in the IS1001 reader's
memory.
The recommendation is to download the contents of memory to
another computer or storage device before erasing memory.
Download Status Reports Memory
Initiates the download of status reports data contained in the IS1001
reader's memory.
The Esc key can be used to cancel the process.
Note: The data will be sent only to the port from which the memory
download was requested.
Save Status Reports to Memory {1} On, {0} Off
Specifies if the short version of automatically generated status
reports will be stored in memory. Valid values are On or Off. Default
is On.
Download Tags Memory
Initiates the download of tags data contained in the IS1001 reader's
memory.
The Esc key can be used to cancel the process.
Note: The data will be sent only to the port from which the memory
download was requested.
IS1001 Reader User Manual