Reports Structures; Full Status Report Structure - Biomark IS1001 Operation User's Manual

Reports Structures

Full Status Report Structure

A full status report contains important configuration settings and diagnostic data for the IS1001
reader. The report can be generated using the RFS command.
Status Message
Reader
ID
Model
S/N
Date
Time
Application Firmware Version
Operation Mode
Network Mode
Exciter Sync. Mode
Date/Time Sync.
Beeper
Tag Display Format
Initiation Delay
Auto Standby Voltages
Periodic Standby Start Time
Periodic Standby Duration
Idling Time
Alarms
Antenna Current Low Alarm
Noise High Alarm
Tuning Capacit. High Alarm
Tuning Capacit. Low Alarm
Alarms Unique Delay
Antenna/Tuning
Exciter Voltage Level
Dynamic Tuning
Tuning Target Phase
Tuning Target Phase Deviation
Threshold
IS1001 Reader User Manual
Message Information
Reader ID setting in HEX (01-FF)
Reader Model (IS1001/IS1001-12V)
Reader Serial Number (YYWW.XXXX)
Reader date setting
Reader time setting
Application firmware version
Reader operation mode setting (Scan/Standby)
Reader network mode setting (IS1001 Standalone/MTS Node)
Reader exciter synchronization mode setting (Master/Sec. Master/Slave/Standalone)
Reader real-time clock synchronization setting (Enabled/Disabled)
Reader beeper setting (Enabled/Disabled)
Tag ID display format setting (Hex/Dec)
Reader automatic diagnostics delay setting (Enabled/Disabled)
Reader automatic standby activation and deactivation voltages settings in Volts (16-
24,17-25)
Reader periodic standby activation time settings in hours (00-23)
Reader periodic standby duration settings in hours (00-23)
Reader idling time setting in milliseconds (0 – 10000)
Antenna current low alarm threshold setting in Amperes peak-to-peak (0.0 – 9.0)
Noise high alarm threshold setting in percent (0 – 100)
Tuning capacitance high alarm threshold setting (512 – 1023)
Tuning capacitance low alarm threshold setting (0 – 511)
Alarms unique delay setting in seconds (Disabled/1 – 3600)
Exciter voltage level setting (1 – 5)
Dynamic tuning setting (Enabled/Disabled)
Dynamic tuning target phase setting (0 – 1023)
Dynamic tuning target phase deviation threshold setting (2 – 63)
Reports Structures
39