Biomark IS1001 Operation User's Manual page 35

CRR {F|S}
CSL {bps}
CTL {1|0}
Detection
DCS {1|0|R}
DET {1|0}
DFH {1|0}
DFT {45-500}
IS1001 Reader User Manual
ASCII protocol is used in conjunction with either BioTerm or BioStat
program to monitor, maintain, and update the IS1001 reader.
MODEM protocol is used in conjunction with Biomark Data
Collection Application to collect data via Sierra Wireless AirLink®
LS300 gateway modem.
Set Remote Comm. Port Transfer Rate {F} Full, {S} Slow
Sets the data transfer rate of the remote communication port. Valid
options are Full or Slow. Default is Full.
Slow transfer rate option should be used whenever external
communication hardware has limited data transfer capabilities.
Set Local Communication Port Speed
Sets the speed of the local USB communication port. Valid options
are 9600, 19200, 38400, 57600, or 115200. Default is 115200 bits/s.
Set Tags Communication to Local Port {1} On, {0} Off
Specifies if detected tag IDs are sent to the local USB
communication port. Valid options are either On or Off. Default is
On.
Note: This parameter does not apply to previously detected tag IDs
that are stored in memory.
Also Note: The Detection Unique Mode (DUM) setting will be used
to determine if duplicate tag IDs are sent to the USB port.
Set Detection Counter {1} On, {0} Off, {R} Reset
Specifies if you want to keep a running count of the tags that are
detected. Valid values are On, Off, or On+Reset. Default is On.
The detection counter counts detected tag IDs and depends on the
Detection Unique Mode settings. It does not count Virtual Test Tag
detections. It resets to 0 whenever the IS1001 reader resets, powers
up, or you activate the Reset option.
Set Detection Efficiency Test {1} On, {0} Off
Enables the detection efficiency test. This is used to qualify the
performance of the entire system. When enabled, a detection
efficiency report will be generated every 4 seconds. Valid values are
On or Off. Default is Off.
Efficiency is calculated as a percentage of the number of detections
vs. the maximum possible over the allowed time interval. This test
will work with physical tags and with a Virtual Test Tag.
Set FDXB Fastag Detection {1} On, {0} Off
Specifies if FDX-B Fastag tag detection is enabled. Valid values are
On or Off. Default is Off.
Set FDXB Detection Scan Time in milliseconds (5ms increments).
Commands
31