First Steps In The App - Rehau NEA SMART 2.0 Service Manual

8.3.4

First steps in the App

Personalize rooms
Each room can be personalized with an own name and an individual
picture or icon.
The rooms will be named Master-1, Master-2 and so on unless they
have been given names already during the set up on the web page of
the NEA SMART 2.0 installation.
To change the name of the room, choose the room in the main
screen. The main room screen will be displayed:
Fig. 8-34 App: Main room screen
Push the three dots on the upper right part of the screen and choose
"Settings" and then "General" to get to the screen to change name
and picture of the room.
Create zones and include rooms
In some cases, several rooms may be put into one zone, e.g. main
floor and first floor. To do so, got to "More" in the main screen, then
chose "Rooms/Zone". New zones can be created after pushing the
"Plus" icon. Rooms can be added to a zone once the new zone is
created.
Choose Energy Level for rooms
Rooms can have the following energy levels:
- Timed mode: rooms will follow the timing programs assigned to this
rooms and will switch automatically between normal and reduced
mode
- Normal mode: rooms will follow the set point that has been set for
normal mode
- Reduced mode: rooms will follow the set point that has been set for
reduced mode
- Standby: Rooms will not follow any set point. Only frost protection
is active and rooms will be heated, once their temperature drop
below 7 °C
- Vacation: Rooms will follow the set point that has been given for
vacation.
- Party: Room will follow the set point for normal mode for the time
choosen for party mode..
Fig. 8-35 App: Energy levels for rooms
The different levels can be assigned to the rooms either:
- In the main screen by pushing the Energy Level button
- Inside the main rooms screens
Choose set points for temperature in timed mode
For each room, there can be a set point defined for normal mode and
reduced mode. To change these set points, choose the individual
room in the start screen, push the three dots on the upper right part
of the screen and choose "Settings" and then "Set points Room
Temperature". In this screen, the set points can be adjusted.
89