Pairing Of Nea Smart 2.0 Room Probes; Pairing Of Nea Smart 2.0 Outdoor Sensor; Further Settings On Nea Smart 2.0 Room Units - Rehau NEA SMART 2.0 Service Manual

7.4.4

Pairing of NEA SMART 2.0 Room probes

The Room probes have no display or key on the front side, only a red
LED in the middle of front plate.
Pairing is done by using a screw driver and pressing an internal button
on the right bottom side. Waiting for pairing is displayed by blinking
shortly twice, and a 1-sec pause.
Fig. 7-4 Pairing procedure on Room probes
Pairing is confirmed by blinking slowly 2 times. Pairing failure is 3
times blinking fast and a 1-sec pause.
7.4.5

Pairing of NEA SMART 2.0 outdoor sensor

Note:
The wireless outdoor sensor is paired to any channel of the NEA
SMART 2.0 Base, no matter whether this channel is used already or
not.
- Open the cover of the sensor
- remove the isolation stripe of the battery
- press the small button for 3 seconds
Fig. 7-5 Pairing outdoor sensor
54
7.4.6
Remark:
The below listed menu points are only available in the first 48 hours
after pairing the room unit.
If you want to use these features after this time span:
- Open front plate
- For wireless room units: remove one of the batteries
- Press home button several times
- For wireless room units: insert the batteries
- Close front plate
Press ok
1
> 3 sec
After this procedure, the room unit shows:
2 Start up sequence
Connected channels
3
Room temperature value
4
Fig. 7-6
If you have an already paired room unit (not longer than 48 hours ago
or prepared as described in last paragraph), you can use some features
shown in the flow chart below.
> 3 sec
By pressing OK long you jump to
1
installer level
2
To show the already paired channels, press minus symbol
To start pairing sequence again (NEA SMART 2.0 Base must be in
pairing mode), press plus symbol
By pressing OK, the next screen appears. You leave this mode by
double clicking OK (or wait some time).

Further settings on NEA SMART 2.0 Room units

Restart of already paired
1
Room unit
2
Shows start up sequence
3
Shows connected channels
Shows actual value of
4
temperature, switches off after
some seconds
Settings Nea Smart 2.0 Room units
4
3