System Data; Diagnosis / Probe Calibration; Settings (Parameters) - Rehau NEA SMART 2.0 Service Manual

7.6.3

System data

Fig. 7-41 Webpage: System data
Note:
The "System" page is present in the user area, too.
Some of the settings are already done during wizard run, as language,
building type and building energy class, but can be modified here.
Temperature unit can be switched between Fahrenheit and Celsius
System date and time has been set during wizard and can be adjusted
here.
The time spans for heating (1st of October until 1st of may) and
cooling period (1st of June until 1st of September) are predefined.
They can be adjusted or completely disabled.
70
Note:
The defined time span is the permission for the system to enter this
mode.
Depending on the system configuration it is also possible, to overrule
the defined periods.
The summertime (daylight saving time) is disabled, when 00-00 is
entered.
Heating mode starts, when the average value of the outside tempera-
ture falls below 15 °C. This limit can be increased or decreased.
Unique code is the identifier for the base in cloud connection
Software versions of installed components.
Note:
Software of Base can be updated automatically from the cloud.
7.6.4

Diagnosis / probe calibration

Fig. 7-42 Webpage: Diagnosis
The Diagnosis page is for service personnel.
System statistics show the runtime of the system and other values.
Configuration overview lists the components of the system.
State of inputs / outputs can be used to verify correct operating of
connected devices and the digital and analogue inputs / outputs of
system components.
7.6.5

Settings (Parameters)

Fig. 7-43 Webpage: Settings