End Of Wizard, Enable Or Disable Automatic Mode; Installer Main Menu - Rehau NEA SMART 2.0 Service Manual

7.5.17 End of wizard, enable or disable automatic mode

When the Base has been configured, the wizard returns to the page
where the overview is given, now showing status OK.
Fig. 7-30 Webpage: Device configuration
You may now enable automatic switching between heating and cooling.
This option is shown only when there is any room defined for cooling,
and:
- Aninput signal "Heating" or "Cooling" or
- An output signal "Heating" or "Cooling"
If in a heating/cooling installation the conditions above are not fulfilled,
you will see the message:
WARNING
This installation is configured for heating and cooling. There are
no output signals or input signals defined to ensure proper
change between heating and cooling mode. You have to ensure
by other means to avoid damage or problems when the system
is switched between heating and cooling.
Automatic switching between heating and cooling is disabled.
On the last screen you get a confirmation, that the system configurati-
on is completed.
Fig. 7-31 Webpage: System configuration completed
66
After pressing OK you come to installer area for further settings.
Once the system configuration is done, there is a time
delay of about 10 minutes before the NEA SMART 2.0
system will start working. During this time, all data from all
components is processed and analysed.
7.6

Installer main menu

Fig. 7-32 Webpage: Installer main menu
The installer main menu offers the following options:
Go back to System set up procedure (Wizard)
Set room names, define set points, declare room as pilot room, set
function of external input of room unit ...
Modify weekly and daily timer programs
Adjust all parameters
Set language, define heating and cooling period...
System components, state of inputs and outputs of all components,
calibrate sensor inputs