Configuration Wizard; Introduction; Preparation - Rehau NEA SMART 2.0 Service Manual

7.5

Configuration Wizard

7.5.1

Introduction

The configuration wizard is a tool which allows you to set up a system,
starting from simple applications as a room temperature control system
for heating up to complex installations with several NEA SMART 2.0
Bases, including mixed circuits and dehumidification.
The wizard leads you through the different steps of the configuration,
and ensures, that you will not forget to configure devices which are
needed in your system. What you need is a smart phone, a tablet or a
laptop with a common internet browser.
1
< OK >
> 3 sec
Activate WIFI/LAN functionality by si-
multaneous-ly pressing < and > for
3 secs
5
< OK >
< 1 sec
Confirm WIFI/LAN AP mode by pres-
sing OK
9
Password:
********
Default WIFI WPA Key
Insert WPA2 key. The default key is
shown on the label of the base and
on the sticker that can be found on
the front page of the instruction ma-
nual. After connection the WiFi/LAN
LED is continuously ON.
56
2
RZ11 RZ12 COOL ZBUS1
DI3 DI4 WIFI/LAN AP
WIFI and LAN o
WIFI/LAN AP
LEDs WIFI/LAN and AP are blinking
simultaneously
Cloud Mode
WIFI/LAN AP
6
Access Point Mode
WIFI/LAN AP
WIFI/LAN LED is blinking, AP LED
is ON
10
Browser:
192.168.0.2
Start your browser and enter in the
web address line the
192.168.0.2
IP address
7.5.2

Preparation

The NEA SMART 2.0 Base has an integrated LAN / WLAN (WiFi)
module. To use the configuration wiz-ard, you have to connect your
device (smart phone, tablet, ...) in AP mode to the NEA SMART 2.0
Base.
Remark:
LAN and WLAN are working in cloud mode (to access to cloud server)
or in Access Point mode (AP mode). In AP mode only 1 device can be
connected.
In delivery state, WIFI/LAN of NEA SMART 2.0 Base is switched off.
Follow these steps:
3
< OK >
< 1 sec
Confirm by pressing OK
7
WIFI
or
WIFI
ON
ON
Prepare your device: Go to settings,
then to WIFI/WLAN settings
11
Follow instructions in browser.
For activating cloud-access installati-
on: enter WIFI SSID and password for
your home WIFI in the browser setup.
4
< OK >
< 1 sec
Change operating mode by
pressing > to AP mode: WIFI/LAN
LED is blinking, AP LED is ON. You
can change between the different
modes by pressing > or <
8
select
NEASMART2
WiFi
Select the network
NEASMART2-XX..XXX