Advertisement
TLP Pro 1225TG and TLP Pro 1525TG • Setup Guide
Mounting
A range of optional mounting kits are available for both models. The
kits must be purchased separately. Follow the installation instructions
provided with the kit.
Removing the back and base covers
Some of these procedures require the back and base covers to be
removed. You must remove the back cover before you can remove the
base cover.
Use the provided Extron removal tool. There is one notch on each
1.
side of the back cover (figure 1,
release the catch.
Use the removal tool to remove the base cover. There are two
2.
notches at the back of the base (
Desktop Mounting
The TLP Pro 1225TG and TLP Pro 1525TG come assembled
with stands that allow the units to be placed on any suitable flat
surface (for example a desk, table, or lectern).
Fixed Mounting
Figure 2 shows the base of the TLP Pro 1225TG, with the cover
removed to indicate the position of the mounting holes (see
1
figure 2,
). The base of the TLP Pro 1525TG is similar and the
spacing of the mounting holes is identical.
Mark the location for two holes, 4.96 inches (126 mm) apart.
1.
This measurement is the same for both models.
Drill two pilot holes into the desktop.
2.
Remove the base cover (see Removing the back and base
3.
covers, above).
Insert two #10 flat-head wood screws (not provided) through
4.
the touchpanel and align them with the two pilot holes.
Secure the touchpanel to the tabletop.
5.
Replace the base cover.
6.
Kensington
Security Lock
®
For added security, attach a Kensington Security Lock (not
provided) to the metal-reinforced Kensington Security Slot
on the rear edge of the base (see figure 3,
shows the rear edge of the TLP Pro 1525TG base, but
the base of the TLP Pro 1225TG is very similar. Follow the
instructions that are provided by the manufacturer to install
the lock.
SMA-1 Swivel Mount Adapter
To swivel either device up to 180° in either direction, use the optional Extron SMA-1 swivel mount adapter, to permanently mount the
touchpanels.
Remove the back cover and base cover (see
1.
Attach the conduit, insulation disk, and swivel disk and configure the set screws to allow for the degree of swivel that is required
2.
(see the SMA-1 Swivel Mount Adapter Kit User Guide, available at
the conduit of the SMA-1.
Secure the unit with the backing plate and locking nut as described in the SMA-1 Swivel Mount Adapter Kit User Guide.
3.
VESA Mounting
Use a third-party D-type VESA mounting kit with the 100 mm x 100 mm mounting pattern.
Remove the back cover.
1.
Remove the four screws holding the touchpanel to the base. There are two screws in each base attachment hinge.
2.
Follow the instructions provided with the VESA mounting kit.
3.
2
1
). Insert the tool into the notch to
2
).
1
). The figure
Removing the back and base covers
Remove the Back and Base Covers
Figure 1.
Mounting Holes in TLP Pro 1225TG Base
Figure 2.
1 1 1
Slot for Kensington Security Lock
Figure 3.
, above).
www.extron.com
). Place the mounting hole in the base over
1 1 1
2 2 2
1 1 1
Advertisement
