Install The Gauge Wheels; Gauge Wheel Mounting Locations; Mount The Gauge Wheels - Raven AutoBoom Installation Manual

Chapter 3

Install the Gauge Wheels

Gauge Wheel Mounting Locations

Wheel mounting locations may be influenced by the boom configuration. Determine the appropriate location for
mounting the wheels on the boom, ensuring the wheels will not interfere with or be damaged while folding or
unfolding the booms.

Mount the Gauge Wheels

Note:
The appearance of the wheel axles may vary, depending on the type of wheel axle kit that was
ordered.
Gauge Wheel Installed
FIGURE 7.
Remove the nuts from the wheel axle.
1.
Place the wheel (P/N 322-0131-008) on the wheel axle.
2.
Reinstall the lug nuts on the wheel axle to secure the wheel.
3.
Mount the receiver bracket (P/N 116-0159-537) to the front of the right boom inside the first fold joint using
4.
two 3-1/16" W x 4" L x 3/8" thread U-bolts (P/N 107-0171-608) and four 3/8"-16 zinc flanged lock nuts (P/N
312-1001-164).
Insert the wheel axle into the receiver bracket, positioning it so that the bottom of the wheel touches the
5.
ground (or nearly so) and the wheel faces away from the machine.
Secure the gauge wheel assembly in the wheel mounting bracket by installing two 1/2"-13 x 1-1/2" SS hex
6.
bolts (P/N 311-0058-186) and two 1/2"-13 zinc hex nuts (P/N 312-1001-043).
Repeat the steps above to install the left wheel.
7.
14
WARNING
The machine must remain stationary and
switched off, with the booms unfolded and
supported, while installation or maintenance is
conducted.
Redball 690 AutoBoom Installation Manual