Table of Contents
Advertisement
The current printer settings will be displayed as follows:
Move Cursor to option and SPACE to cycle through valid parameters.
Touch ESC to exit or R to reset to original values.
OPTION
PRINTER
Baud Rate
1200
Stop Bits
1
Word Length
7
Parity
None
Clear-to-Send
Ignore
Carr ier Detect
Ignore
Protocol
XON/XOFF
•
Check your printer's manual for the "Baud Rate", "Parity" and "Proto-
col" information called for in the menu.
•
To change the menu items for your printer:
Press the SPACE BAR to step through the selections for each item.
Press the down arrow key to move to the next item.
Press the up arrow if you want to move back up the list of items.
•
Check that all items are set correctly for your printer
•
Press ESC when you have finished
•
Press ESC again
The following message is displayed on the screen:
The selections you have made are not yet in effect.
Please enter one of the following:
S
=
Save and activate the selections permanently.
Q or ESC
=
Quit without making any changes.
T
=
Temporarily activate the selections - but do not save them.
•
Type S to save the changes on your disk.
•
Continue with the' instructions on page 13-10 to finish changing your
software. Instructions for installing the cable to connect the printer to
the 820-11 are in the SYSTEM COMPONENT section of this manual.
DIRECTORY
3-16
(
Advertisement
Table of Contents
