Table of Contents
Advertisement
PREPARING TO RUN DIAGNOSTICS ON A NEW 820-n
Your 820-11 Personal Computer comes with an 820-11 Diagnostic Exerciser disk in the disk
drive box. You can use this disk to check that your system
is
in proper working order. The
disk will check the different components of the system and display a message if it finds a
malfunction.
It's a good idea to check your system when you first install it.
If
you experience any
problems while using the system, you can use the 820-11 Diagnostic Exerciser disk to check
the system and find out if it needs to be
serviced (repaired).
If
you have just installed a new 820-11 proceed with the steps below.
If
you've already used
the 820-11 turn to page 15-5.
.
COMPARE your disk drive unit to the illustration below to determine what type of
drive you have.
DRIVE
A
DRIVE
B
5~"
DISK DRIVES
8" DISK DRIVES
DRIVE
B
OPEN
the disk drives by pushing on the latch or button as shown above.
LOCATE
the ON/OFF switch on the left side of the 8" disk drives (the
5~"
disk
drive does not have an ON/OFF switch).
LOCATE
the ON/OFF switch under the right side of the screen toward the back.
RESET
BUTTON
(on
bode
of screen)
SCREEN
ON/OFF
SWITCH
DIAGNOSTICS
15-1
8" DISK DRIVES
Advertisement
Table of Contents
