Table of Contents
Advertisement
8.
To replace the platen:
a.
Hold the pIa ten over the release levers.
b.
Lower the left side of the platen and push the left release lever back with
the metal platen rod until the groove falls into the guide.
c.
Lower the middle of the platen behind the plastic paper guide.
d.
Push the right release lever back with your right thumb far enough to
lower the metal pIa ten rod into the right guide. The release lever will
snap over the rod when you have placed the rod in the correct position.
9.
Reinstall the printwheel and ribbon.
10.
Lower the tissue deflector, paper bail and typewriter cover.
SYSTEM COMPONENTS
14-19
Advertisement
Table of Contents
