Table of Contents
Advertisement
Setting The Operating Switches
These six switches are located in the right-hand area of the control panel where they
are accessible to the operator with all covers on the machine. These are membrance
type momentary action switches actuated by a touch of the finger.
1.
RESET Switch. This switch will restore the printer to normal operating status
following a printer check or an error condition, and clears all error indicators.
2.
SCROLL Switch. Touching this switch advances the paper a small amount to
give the operator a clear view of the last printed line.
The paper is
automatically returned to the last printing position when the switch is released.
3.
LINE FEED Switch. Touching this switch initiates a single or a double line feed
operation, as selected by the DOUBLE L.F. MODE SWITCH. Action is repeated
if the switch is held activated longer than 600msec. A line feed code will not
be transmitted.
4.
FORM FEED Switch. Touching this switch initiates a form feed to the next
top-of-form position. A form feed code is not transmitted.
5.
HERE IS Switch. Touching this switch causes a special "Here Is. ." message
of up to 31 characters to be transmitted over the communications link when
operating in remote ASCII mode with the fully featured HPR05 option
installed. This
is
not used with the Xerox 820-11.
.
6.
BREAK Switch.
Touching this switch causes a Break (250m sec space) to be
transmitted over the communications link when operating in remote mode.
7.
Audio Alarm. This device buzzes briefly to indicate the occurrence of various
errors or operating conditions.
SYSTEM COMPONENTS
14-38
Advertisement
Table of Contents
