Table of Contents
Advertisement
TYPE
the number 3
Result
The following message is displayed on the screen:
Are you ready to ERASE (initialize) the disk in physical drive B
(YIN)?
TYPE
WAIT
the letter
Y
to initialize the disk in drive B
several minutes for the message "0 Defective Sectors" to display on the
screen.
If
the disk has defective sectors (areas on the disk that aren't good) as indicated by a
number other than 0 in front of the "Defective Sectors" message, do not use it -
initialize another disk using the steps below:
• Replace the disk in Drive B with another disk
f)
Touch any key and follow the directions on the screen •
• Wait for the "0 Defective Sectors" message to display on the screen
REMOVE
both disks.
You're now ready to check out the system with the Diagnostic Exerciser disk. The
instructions for running diagnostics are on the next page.
DIAGNOSTICS
15-4
Advertisement
Table of Contents
