Table of Contents
Advertisement
Inserting Paper or Forms
Inserting paper or forms into the 630 Printer (40 CPS) is accomplished in much the
same manner as in a standard typewriter. Paper is inserted down behind the metal
paper out bail and platen while the platen is turned manually to bring the paper
around and up in front of the platen. The front paper bail aids in guiding the paper
back over the platen to the rear when pulled forward. The paper release lever at the
right-hand side of the printer may be pulled forward to release roller pressure after
paper insertion so the paper can be properly aligned in the printer. After paper is
positioned, both the front paper bail and paper release lever are returned to their
operating positions.
Press the RESET switch on the front of the printer.
Paper Thickness/Print Intensity Adjustment
The two-position Multicopy lever located at the front of the carriage assembly
adjusts for paper thickness and print intensity. Setting the lever to its upper position
moves the carriage close to the platen, and actuates a switch to the proper setting
for light and medium weight paper and form sets of up to two carbon copies.
For
heavier paper or form sets of up to five copies, the Multicopy lever is set to its lower
position. This rocks the carriage away from the platen slightly, and deactivates the
switch to enable an increased print intensity.
To avoid the possibility of ribbon damage, the Multicopy lever should always be set at
its upper position when printing on single sheets of paper using carbon ribbons.
SYSTEM COMPONENTS
14-34
Advertisement
Table of Contents
