Table of Contents
Advertisement
Installing a Ribbon Cartridge
1.
Take up any tension in the ribbon by turning the colored knob on the top of
the cartridge in the direction of the arrow.
2.
Move the red CARTRIDGE RELEASE LEVER at the side of the carrier to
the open position.
3.
Return the CARRIER LATCH if it is not released.
4.
Hold the cartridge in both hands, tilt the back of the cartridge down, and
slide it backward into the rear guide as you lower it onto the carrier (see
illustration below).
5.
As you lower the cartridge, position the ribbon between the plastic card
guide and the ribbon guides until the cartridge fits securely on the carrier.
6.
Slowly move the CARTRIDGE RELEASE LEVER to its locked position.
7.
Push the carrier forward and hold it in place while you push the CARRIER
LA TCH forward into its groove.
SYSTEM COMPONENTS
14-14
Advertisement
Table of Contents
