Table of Contents
Advertisement
OPERATING THE 630 PRINTER (40 CPS)
Preliminary Steps
1.
Install a print wheel, a ribbon cartridge and insert a sheet of paper.
2.
Move the carriage manually to the right a short distance.
3.
Move the power ON/OFF switch at the right rear of the printer to ON.
The POWER indicator should glow; the carriage should move to the left slowly, and
then back to the right, to stop at the first print position; and the print-wheel should
rotate and stop. at its "home" position (i.e., the "flag" on metal printwheels should be'
at the top if the Print wheel Select switch - under the access cover - has been
properly set). This entire process is called the INITIALIZATION, RESET or RESTORE
sequence. It clears all volatile memory, resets all position counters and sets the 630
Printer (40 CPS) to print the first character.
Paper Handling Accessories
Forms Tractor/Pin Feed Platen: These devices facilitate precision handling of the
continuous or manifold paper forms and are provided in both unidirectional and
bidirectional versions.
Mechanical Front Feeder:
This device also mounts on top of the 630 Printer
(40 CPS). It is intended for use with difficult, multipart forms and the heavier ledger
card stocks.
Bottom Feed: The 630 Printer (40 CPS) can be configured for feeding continuous or
manifold forms up through the bottom of the machine. It must be used with either a
pin feed platen or a forms tractor.
SYSTEM COMPONENTS
14-35
Advertisement
Table of Contents
