Wavetronix SmartSensor V User Manual page 21

Note. When you run
the cable through
the pole, don't drill
through the sensor
mount, as the sensor
and sensor mount
may need to be
adjusted in the future.
SmartSensor V User Guide
20
•
Twist the cable connector clockwise until you hear it click into
2
place.
Run the cable through the pole. Leave a small amount of slack
3
at the top; this reduces strain, allows you to create a drip loop
as shown above, and gives you something to work with should
you someday need to move the sensor to a different spot on
the pole.
If there's excess cable, don't cut it, as you may need it at a later
4
time; leave it in the pole.