4.
Pipe couplings are lightly oiled before
assembly.
5.
Grease the axles for protection against
corrosion before the wheels are fitted.
6.
The spacer sleeves on the inside of the
wheels are of different lengths.
Left 36.3 mm with washer
Right 45.5 mm, no washer
Do not mix up the rear axle's spacer sleeves.
7.
Fill with oil and bleed the complete
hydraulic system according to "Bleeding
the drive system".
8.
Check and adjust the parking brake
cable.
9.
Check and adjust the speed coordination
between the front wheels and rear
wheels according to the separate
instruction.
Rear axle
Removal
1.
Jack up and block the machine
2.
Remove the rear wheels.
•
Remove the protective cover.
•
Remove the circlip.
•
Pull off the wheel with hub from the axle.
•
Take care of the keys, spacers and
washers, keep a check of the number of
washers, this can vary between sides.
REPAIR INSTRUCTIONS
Jacking up
Circlip
8009-651
8009-825
67
English-