Table of Contents
Advertisement
2.
Remove the cover and pull out the filter.
3.
Fit the new filter in position. Coax it in so
that the rubber seal in the front end-plate
enters its position. If the spring protrudes
so that it must be pressed together
before the cover "threads catch" the filter
is not in the right position.
IMPORTANT INFORMATION
The cover is made of plastic. Do not tighten
it too tight so the threads are damaged.
4.
Fit the cover.
Adjusting the lever housing
The lever housing on these types of machine
only has two settings.
•
Adjuster nuts for the cutting unit's
mowing height range. See "Adjusting the
Cuttin Height Range".
•
Adjuster screw for the belt adjuster's
home position.See "Replacing the
Centre Belt".
REPAIR INSTRUCTIONS
Hydrostatic transmission filter
Adjuster nuts
Adjuster screw
6020-003
8009-281
8009-843
85
English-
Advertisement
Table of Contents
