Removing The Kawasaki Engine - Husqvarna Rider 13 AWD Workshop Manual

Removing the Kawasaki engine

1. Remove the engine cover and
transmission cover.
2. Loosen the battery's retaining strap.
Remove the protective cover.
IMPORTANT INFORMATION
Hold the battery cable bolts in place so that
the electrodes are not strained.
3. Loosen the battery cable connections.
Then lift out the battery.
4. Remove the cable connecting the starter
relay to the starter from the starter.
5. Mark and remove the engine's electrical
connectors.
6. Remove the clips holding the throttle and
choke cables. Unhook the cables from
their fasteners in the carburettor.
7. Remove the hose clamp on the fuel hose
by the fuel pump and pull the fuel hose
downwards. Place the hose so that the
fuel does not leak out.
REPAIR INSTRUCTIONS
Battery installation
Connections, to the left of the front of the engine
Throttle and choke cables
Fuel pump
8009-526
8009-190
8009-527
8009-191
41
English-