•
Remove the circlip.
•
Pull off the wheel with hub from the axle.
•
Take care of the keys, spacers and
washers, keep a check of the number of
washers, this can vary between sides.
4.
Release the front synchronisation link for
speed from the front axle.
•
Check in which hole the synchronisation
link is fitted (normally over the hole).
5.
Drain out the oil if necessary, two plugs.
6.
Release the hydraulic pipe from the
underside of the front axle. Fit the
protective plugs. A small amount of oil
will leak out even if the front axle has not
been drained.
7.
Remove the left front wing.
64
English-
REPAIR INSTRUCTIONS
Circlip
Synchronisation link
Oil drainage
Hydraulic pipe, underside
8009-825
8042-121
8009-631
8009-623