Removing The Bioclip Plug (Combi) - Husqvarna Rider 13 AWD Workshop Manual

!
WARNING!
If the blades are cracked, whether
caused by poor repair or other
damage, they could break while
being used. The risk increases if
the blades are poorly balanced.

Removing the BioClip plug (Combi)

To change a Combi unit from the BioClip
function to a cutting unit with rear ejection,
remove the BioClip plug, which is located
under the unit, attached with three screws.
1. Put the unit in service position, see
page 106.
2. Combi 103, 112
Remove the three screws holding the
BioClip plug, and remove the plug.
3. Combi 103, 112
Tip: Fit three full-thread screws M8 x 15 mm
in the screw holes to protect the threads.
4. Combi 94
Remove the wing nut and BioClip-plug.
5. Return the unit to the normal position.
Fit the BioClip plug in the reverse order.
REPAIR INSTRUCTIONS
Removing the BioClip Plug Combi 103, Combi 112
Removing the BioClip Plug Combi 94
8009-289
6021-023
113
English-