Table of Contents
Advertisement
You can purchase the entire assembly,
complete with shaft housing, shaft, spacer,
and bearings.
Fit in the reverse order to removal. Make sure
that the shaft is mounted in the same
direction as when it was removed, otherwise
the keys will not fit the grooves.
IMPORTANT INFORMATION
When tightening the blade shaft screws,
the transmission side should always be
tightened first and then the blade screws.
Tighten the blade bearings with a torque of
20–25 Nm (14–18 lb-ft).
Tighten the blade bolts with a torque of 45–
50 Nm (32–36 lb-ft).
Combi 94, Combi 103
!
WARNING!
Use gloves and protective eyewear
when working with the cutting unit.
You can recognise these cutting units by the
fact that the collar on the bearing housing is
located on the underside of the cutting unit's
cover.
1.
Remove the cutting unit's upper cover,
see "Belt Replacement: the Combi 94,
Combi 103, Combi 112".
2.
Loosen the spring (1) that tensions the
V-belt and pull the belt off.
3.
Loosen the screw that holds the belt
pulley (2) a few turns. Lock the blade
with a wooden block or hold the belt
pulley in place, with an oil filter wrench,
for example.
110
English-
REPAIR INSTRUCTIONS
Repair kit
Belt adjuster spring and belt pulley
Locking the blades
6012-087
8009-303
8009-292
Advertisement
Table of Contents
