Rear Axle - Husqvarna LC 247Li Workshop Manual

13. Disconnect the plastic stops with a snap ring pliers.
14. Pull the rear axle and the gearbox out from the
product.
15. Install the gearbox in the opposite sequence. Use
the correct torque. Refer to
page 11 .
26 - Repair instructions
To stop the product on

7.7 Rear axle

7.7.1 To disassemble and assemble the rear axle
(LC 247Li and LC 247iX)
1. Remove the rear wheels. Refer to
attach the wheels on page 22 .
2. Adjust the cutting deck to its highest position.
3. Turn the product on its side. Use pieces of wood to
make sure that the product is stable.
To remove and
361 - 001 -