Replacing The Steering Cables - Husqvarna Rider 13 AWD Workshop Manual

Hide thumbs Also See for Rider 13 AWD:
Table of Contents

Advertisement

REPAIR INSTRUCTIONS
8009-372
Power steering and steering cables

Replacing the Steering Cables

Loosen the steering cables' rear mount (1).
Remove the frame plate.
Loosen the steering cables' front fixture (2) by the steering chain (3) and pull out the steering cables
through the frame.
Note If the old cables are whole, the new cables can be attached to the old when they are pulled out
through the frame. The new cables will then automatically sit in the proper position.
The steering cable's chain coupling should be fitted with the spring lock upwards.
Hold the cables with, for example, a wrench when mounting so that they do not twist.
Ensure that the steering wheel is in the centre position when the rear wheels are centred. Re-set the chain
on the power steering sprocket or adjust the rear fixture for the steering cables (1) as needed.
When the new cables are mounted, the cable tension should be checked (see "Checking and Adjusting the
Steering Cables").
53
English-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rider 175 awdRider 15v2 awd

Table of Contents