4.
Press in the cable casing in the forward
fastener in the centre bracket.
5.
Tighten the hydrostatic transmission
cable's front clamp. Press the link joint
onto its fastener and attach the locking
spring.
6.
Attach the link joint to the rear part of the
hydrostatic transmission cable.
Screw 10–12 turns so that the link joint
has the right length.
7.
Run the hydrostatic transmission cable
along with the other cables.
8.
Position the hydrostatic transmission
cable in the casing's rear bracket and fit
the rear clamp.
9.
Adjust the hydrostatic transmission cable
as shown, see "Adjusting of the
Hydrostatic Transmission Cable".
78
English-
REPAIR INSTRUCTIONS
Forward mount in centre bracket
Front clamp
Rear link joint
Adjusting the hydrostatic transmission cable
6019-023
6019-024
6019-025
8009-819