Reparation Instructions; Removing Engine - Husqvarna Rider 13C Workshop Manual

Removing engine

The figures under "Dismantling" show Rider 11 C,
Rider 13 C and Rider 16 in older designs (R16 up
to the 2002 model), for a more recent Rider 16
design (2003-) see "Assembling the engine". The
text applies to all versions.
1
IMPORTANT INFORMATION
Hold the bolts so that the poles are not
put under strain.
Remove the battery's fixing belt. Remove the
safety guard and remove the cable connections.
Then, lift out the battery.
2
Remove the cable which leads from the starter
relay to the start motor.

Reparation instructions

3
Mark up and remove the engine's electrical
connections.
Newer engines, pull the connector apart.
4
Remove the clamp holding the throttle and choke
wire. Unhook the wire at its at its attachment.
23
English –