Reparation Instructions; Removing Engine - Husqvarna Rider 11 Workshop Manual

Removing engine

1
Remove the battery's fixing belt. Remove the safety
guard and remove the cable connections. Then, lift
out the battery.
2
Remove the cable which leads from the starter
relay to the start motor.
16
– English

Reparation instructions

3
Mark up and remove the engine's electrical
connections.
4
Remove the clamps which hold the throttle and
choke wires. Unhook the wires from their
attachment in the carburettor.
Rider 11/11 Bio, Rider 13 H/13 H Bio and Rider
16 H have just one wire which controls both the
throttle and the choke.