Table of Contents
Advertisement
Checking the blades
To achieve the best mowing results it is important that the
blades are undamaged and well-sharpened.
Check that the blades' attachment screws are tight.
•
Put the unit in the service position, see Service position
for the cutting unit.
The blades should be balanced after sharpening.
Damaged blades should be replaced when hitting obstacles
that result in a breakdown.
IMPORTANT INFORMATION One or more unbalanced
blades , caused by damage or poor balancing after
sharpening, can cause vibrations in the machine.
Replacing the blades
•
Put the unit in the service position, see Service position
for the cutting unit.
•
Remove the equipment frame.
•
Lock the blade with a wooden block. Loosen the blade bolt
and remove the blade bolt, the washer and the blade.
•
Assemble the parts in the reverse order.
24 –
English
Maintenance
•
The blade must be mounted with the angled ends pointing
up towards the cover.
•
Tightening torque 45-50 Nm (4.5-5 kpm/32-36 lbft).
15mm
IMPORTANT INFORMATION Always exercise care and
use your common sense. Avoid all situations which you
consider to be beyond your capability. If you still feel
uncertain about operating procedures after reading these
instructions, you should consult an expert before
continuing. Contact an authorised service workshop.
Always use genuine parts. For more information, see the
"Technical data" section.
Removing the BioClip plug
To change a Combi deck from the BioClip function to a cutting
deck with rear ejection, remove the BioClip plug, which is
located under the unit, attached with a screws.
1 Put the unit in the service position, see Service position
for the cutting unit.
2 Loosen the screw holding the plug and remove it.
3 Fit cutting unit.
4 Fit the BioClip plug in the reverse order.
Advertisement
Table of Contents
