Battery Voltage; Aux Inputs Parameter Menu; Relay Manager - Deif MPC-1 Programming Manual

Max. phase- 12 o
Difference
12 o
Trip vector 2 pe-
jump riods
After 2 periods
Monitoring single
Single phase phase

3.9 Battery voltage

SETTING DIS- Facto-
PLAY ry set
Batt. 18.0V
Undervolt.
U< = 23.5V
NOTE: Regardless of setting, the alarm will occur if:
Voltage drops below 12.7 V (without running start motor)
- Voltage drops below 13.5 V (with running start motor)
4.

Aux inputs parameter menu

DISPLAY Facto-
ry set
Config YES
Inputs?
YES

4.1 Relay manager

DISPLAY Factory
set
Config relay 01
1: 01
Config relay 01
2: 01
Config relay 01
3: 01
F3:
Vector
jump
Commis- ALARM
sioning MESSA-
value GE
F1: batt.
under-
volt.
Commis- DESCRIPTION
sioning
value
YES/NO. If NO is chosen the following sub-
parameters will not be shown.
Commision- DISPLAY
ing value
Config re-
lay 4: 01
Config re-
lay 5: 01
Programming manual MPC-1
3...30 o . Max. phase difference
setpoint.
2...4 periods. Trip time of GCB
(MCB if option A is chosen).
Single phase/three phase.
Selection of 1/3-phase vector
jump supervision
DESCRIPTION
18.0...30.0 V. Battery voltage
low limit. Fixed delay 20 sec.
Factory Commision-
set ing value
01
01
4189340103E