Table of Contents
Advertisement
If the display value has been changed via the "5" or "8" buttons, the new value can
be stored by pushing the "P" button once. If the button is pushed twice, the display will
jump to the next parameter.
2.1.2
"5" pushbutton
Steps the chosen displayed value up one unit (within allowed limits). Digit is chosen
by moving the cursor.
2.1.3
"4" pushbutton
Analog values: Moves the cursor to the next digit
Binary values: Swap of different functions (e.g.: ON/OFF)
2.2 Software version
DISPLAY
Software version
V 1.01
2.3 Code number
DISPLAY
Enter code
Number
xxxx
Factory
Commis-
set
sioning
value
Factory
Commis-
set
sioning
value
random
and
level
Programming manual MPC-1
DESCRIPTION
The software version is factory set.
Check that it matches the version
indicated in the manuals.
DESCRIPTION
The display will show a random no.
The random no. is used at a later
stage if the chosen passwords have
been lost. Call factory for help on the
code to be used.
NOTE: If you change this no., one of
the 2 code level codes must be used
(see later). It is therefore
recommended, that you leave the no.
during programming/commisioning.
4189340103E
Advertisement
Table of Contents
