Safety Information; Warnings - Fluke Calibration 6020 Series User Manual

6020 Series Calibration Bath
User's Guide
1.2
1.2.1
2
Symbol Description
Canadian Standards Association
OVERVOLTAGE (Installation) CATEGORY II, Pollution Degree 2 per IEC1010-1 re-
fers to the level of Impulse Withstand Voltage protection provided. Equipment of
OVERVOLTAGE CATEGORY II is energy-consuming equipment to be supplied from
the fixed installation. Examples include household, office, and laboratory appliances.
C-TIC Australian EMC Mark
The European Waste Electrical and Electronic Equipment (WEEE) Directive
(2002/96/EC) mark.

Safety Information

Use this instrument only as specified in this manual. Otherwise, the protection
provided by the instrument may be impaired.
The following definitions apply to the terms "Warning" and "Caution".
• "Warning" identifies conditions and actions that may pose hazards to the
user.
• "Caution" identifies conditions and actions that may damage the instru-
ment being used.

Warnings

To avoid personal injury, follow these guidelines.
GENERAL
• Appropriate personal safety protection should be worn by the operator at
all times while using the bath.
• DO NOT use the instrument for any application other than calibration
work. The instrument was designed for temperature calibration. Any other
use of the unit may cause unknown hazards to the user.
• DO NOT use the unit in environments other than those listed in the user's
guide.
• DO NOT overfill the bath. Overflowing extremely hot fluid may be harm-
ful to the operator. See Section 5.3, Bath Preparation and Filling, for spe-
cific instructions.
• Follow all safety guidelines listed in the user's manual.
• Calibration Equipment should only be used by Trained Personnel.
• If this equipment is used in a manner not specified by the manufacturer,
the protection provided by the equipment may be impaired.