Setting The Guide - Fein KBE 35 (A) Repair Instructions

Metal Core Drilling
Fitting

9.4 Setting the guide

Tool(s):
- Socket head wrench, 2.5 mm
1
Photo shows similar product
C-SC_CSSM
1.
Version 1.0
All rights reserved by FEIN, especially in case of property rights applications.
FEIN retains all rights of disposal, such as copying and circulation.
Use the six set screws (1) to set zero backlash on the
guide.
I
NFORMATION
To check the setting, move the drill motor up and down using
the spider.
At the places where the drill unit moves too fast or too slowly,
screw the stud bolts in or out a little further.
01.04.2019 Page 73 of 75