Calibration Menu Options; Calibrating The Tanks; Tank And Location Selection - Mercury VesselView Manual

Calibration Menu Options

The "Calibrate" menu will allow you to setup your VesselView to your specific boat. The "Calibrate" menu items include the
following:
• "Tank"
• "Tabs"
• "Trim"
• "Configuration"
• "Factory Reset"
• "Save Configs"
• "Load Configs"

Calibrating the Tanks

Open the "TANK CONFIG" screen by pressing the menu button until the "Main" menu appears. Use the down arrow button to
select the "Calibrate" option. Press the check button to open the "Calibrate" menu, then the check button to select "Tank."

Tank and Location Selection

1. Open the "TANK CONFIG" screen. The engine location box is highlighted.
2. Use the left or right arrow button to choose which engine to configure.
NOTE: You may configure up to two tanks for each engine on the boat if these engines are so equipped. For example, on
a triple‑engine application, six tanks are available.
3. Press the down arrow to proceed to the tank selection box.
4. Use the right arrow button to choose which tank number to configure.
90-8M0070299 MAY 2012
eng
Section 2 - Setup and Calibration
Setup
Main
Calibrate
Favorites
Settings
Calibrate
Calibrate
Alarms
Tank
Settings
System Info
Tabs
Alarms
System Info Trim
Configuration
Maintenance
Factory Reset
Save Configs
Load Configs
a - Engine location
b - Tank selection
a
b
27061
47857
Page 17