Section 2 - Setup and Calibration
4.
Press the check button to import the saved configuration.
5.
VesselView will restart and import the configuration.
NOTE: If the imported configuration settings are correct for your power package, the setup process is completed. Continue to
finalize the setup of VesselView. Refer to Calibration Menu Options .
Engine Setup
VesselView automatically detects the vessel's power package. On the "ENGINE SETUP" screen, you can change the type and
number of engines. The available power packages are:
•
"2 Stroke Gas Outboard"
•
"4 Stroke Gas Outboard"
•
"Gas Sterndrive No Troll"
•
"Gas Inboard No Troll"
•
"Gas Jet Drive"
•
"Gas Sterndrive"
IMPORTANT: If a "Diesel Inboard No Troll" is the identified, VesselView assumes the installed power package is a Zeus drive
and will turn on the AutoPilot screens; Pilot, Joystick, Skyhook. All other drive types, the pilot screens must be turned on or off
in the "Settings" option menu.
NOTE: VesselView will always default to four engines during the initial setup and after a factory reset.
Page 10
IMPORT CONFIG
TO IMPORT CONFIGURATION, INSERT
MEMORY STICK AND WAIT FOR INSTRUCTIONS .
MEMORY STICK READY
•
"Gas Inboard"
•
"Gas Verado"
•
"Diesel Sterndrive No Troll"
•
"Diesel Inboard No Troll"
•
"Diesel Sterndrive"
•
"Diesel Inboard"
4
TO IMPORT
27309
a -
Engine type
b -
Number of engines
a
b
34503
90-8M0070299
MAY 2012
eng