Table of Contents
Advertisement
Section 2 - Setup and Calibration
A vessel configuration is used to assign the VesselView its location on the vessel. It also allows you to select the number of
engines on the vessel and where the engine data should be displayed. To begin vessel configuration, press the menu button
until the "Main" menu appears, then use the down arrow button to select the "Calibrate" option. Press the check button to open
the "Calibrate" menu, then use the down arrow to select "Configuration." Press the check button to open the vessel
configuration screen.
NOTE: The power package can only be changed in the setup wizard. Perform a factory reset to change the power package and
go to the setup wizard. Refer to Factory Reset .
1.
Use the right and left arrow buttons to select the "HELM ID" number.
2.
Press the down arrow button to proceed to "DEVICE ID."
3.
Use the right and left arrow buttons to select the device identification number.
4.
Press the down arrow button to proceed to "NUM ENGINES."
5.
Use the right and left arrow buttons to select the number of engines.
6.
Press the down arrow button to proceed to "RIGHT SCREEN."
7.
Press the left or right arrow button to scroll through the available location types. You may select any of the following,
depending on the number of engines:
•
"NONE"
•
"STBD"
•
"PORT"
•
"CENTER" (triple only)
•
"STBDCNTR" (quads only)
•
"PORTCNTR" (quads only)
8.
If there are multiple engines, press the down arrow to proceed to the "LEFT SCREEN."
9.
Press the left or right arrow button to scroll through the available location types.
10. For three or four engine applications, press the down arrow to proceed to "CENTER SCREEN."
11. Confirm your selections by pressing the check button.
12. VesselView will display the saving settings screen and restart.
Factory Reset
The "FACTORY RESET" menu is used to reset all VesselView settings to factory default or to perform a sensor detection. To
perform a factory reset, press the menu button until the "Main" menu appears, then use the down arrow button to select the
"Calibrate" menu. Press the check button to open the "Calibrate" menu, then use the down arrow to select "Factory Reset."
Press the check button to open the "FACTORY RESET" screen.
IMPORTANT: By selecting "RESET SETTINGS" all vessel data settings will be lost.
1.
The "FACTORY RESET" screen will ask you to "CHOOSE RESET TYPE." The two types of resets are:
•
"RESET SETTINGS"—This will reset VesselView to factory defaults
•
"RESET SENSOR DETECTION"—This will scan the VesselView network for any recently removed or installed
sensors
2.
Use the left and right arrow buttons to select between the two types.
Page 26
a -
Power package name
b -
"HELM ID"—Identifies the helm
a
location of the VesselView
c -
"DEVICE ID"—Unique identifier for the
b
VesselView unit
d -
"NUM ENGINES"—Number of engines
c
e -
"RIGHT SCREEN"—Engine data
displayed on the right side of the
d
screen
f -
"LEFT SCREEN"—Engine data
e
displayed on the left side of the screen
(multiple engines only)
f
g -
"CENTER SCREEN"—Engine data
displayed on the center of the screen
g
(triple and quad engines only)
34244
90-8M0070299
MAY 2012
eng
Hide quick links:
Advertisement
Chapters
Table of Contents
