Mercury VesselView Manual page 17

NOTE: Use "HELM ID 1" for single helm vessels. If a vessel has multiple VesselView units installed on different helms (up
to four maximum) the "HELM ID" represents the helm location where each VesselView is installed (lowest to highest helm
is recommended).
4. Press the left or right arrow on the arrow pad to choose either helm 1, helm 2, helm 3, or helm 4.
5. Confirm your selections by pressing the check button.
6. Press the check button to enter "TAB SETUP."
7. Press the left or right arrow on the arrow pad to identify the propulsion type: "NONE," "MERCURY," "POD."
NOTE: Calibration of the tabs is not required for Zeus power packages.
8. "NONE" is the default selection when no sensors are detected. If tabs are installed, press the down arrow on the arrow pad
to access the number of tabs. If there are no tabs installed, press the "X" button to go back one step to the "TAB SETUP"
screen and continue to step 29.
9. Press the left or right arrow on the arrow pad to select the number of tabs installed. Up to three tabs can be selected.
10. Press the down arrow on the arrow pad to access the "RIGHT TAB" window.
11. Press the left or right arrow on the arrow pad to select the location name for the right, left, and center tabs. The location
names available are:
90-8M0070299 MAY 2012
eng
PROPULSION TYPE
"NONE"
"STBD TAB 1"
"STBD TAB 2"
"PORT TAB 1"
"PORT TAB 2"
"STBD CNTR TAB 1"
TABS
POD
Tab location names
Section 2 - Setup and Calibration
34204
45137
None
Starboard tab 1
Starboard tab 2
Port tab 1
Port tab 2
Starboard center tab 1
Page 13