Mercury VesselView Manual page 26

Section 2 - Setup and Calibration
7. Press the down arrow on the arrow pad to access the "LEFT TAB" window. Press the left or right arrow on the arrow pad to
select the location name for the right, left, and center tabs.
8. Press the down arrow on the arrow pad to access the "CENTER TAB" window. Press the left or right arrow on the arrow
pad to select the location name for the right, left, and center tabs.
9. Confirm your selections by pressing the check button.
10. Press the "X" button to go back to "TAB SETUP" if corrections are needed.
11. Press the left or right arrow on the arrow pad to select the tab to be calibrated.
12. Press the check button to begin calibrating the selected tab.
13. Lower the selected tab into its down position.
Page 22
"STBD TAB 2"
"PORT TAB 1"
"PORT TAB 2"
"STBD CNTR TAB 1"
"STBD CNTR TAB 2"
"PORT CNTR TAB 1"
"PORT CNTR TAB 2"
PROPULSION TYPE
NUMBER OF TABS
RIGHT TAB
LEFT TAB
X = DONE
Tab location names
TABS
MERCURY
2
STBD TAB 1
PORT TAB 2
CHECK = SELECT
Starboard tab 2
Port tab 1
Port tab 2
Starboard center tab 1
Starboard center tab 2
Port center tab 1
Port center tab 2
45138
45139
90-8M0070299 MAY 2012
eng